PPF Kits for every BMW model

We have a PPF kit for every existing model, including BMW 1 series, BMW 3 series, BMW 5 series, BMW X3, BMW X1 and many more...

Application kit

We supply an application kit FREE with every PPF Kit purchase, but if you would like another or just want one, click below

Buy now
  • Concentrated PPF Tack 1:5

  • Squeegee

  • Microfiber Towels

  • 2 Spray Bottles

  • Clay Bar

  • Concentrated PPF Slip 5ml

1 of 6

Video tutorials

Preparing SLIP & TACK


Laying the panel

  • Give it a wash

    Pick a sunny Saturday and start the makeover by giving your BMW a thorough wash. Remove all dirt and debris, paying extra attention to the areas you’ll be applying the film to. 

  • Clay Bar Treatment

    Start with your first panel. Wet it with some slip solution and rub your clay bar over the panel to remove contaminants.  

  • Dry Off

    When its looking smooth, wipe off that excess water with a microfibre cloth or squeegee.

  • Clean with Isopropyl Alcohol

    Wipe down with Isopropyl alcohol until you can see your own reflection.

  • Slip

    Moisten the panel with slip solution. Then spray the exterior of the PPF film with the same solution. Peel the film from its backing and continue spraying the slip solution on its reverse side. Place the PPF onto the panel.

  • Align

    Have a good look at your car. Pick some key features to align your film with such as badges or corners. Once you’re cool with the fit, lift the film and apply a generous amount of tack on the area. Realign the film and squeegee out that moisture for a strong tack. Once tacked, don’t squeegee slip solution onto this area.

  • Stretch

    To fit the curves of a BMW, the film must be stretched. Choose an opposing corner to tack and stretch the film, aligning with the edge of the panel. Tack it down, then tackle the others.

  • Squeegee

    Squeegee out the solution from beneath the film using firm strokes. Ensure all moisture is removed to prevent silvering. Video to savour the satisfaction.

  • Edges

    Once all of the slip solution is squeegeed out, you can start to address the edges. Use firm squeegee strokes to wrap round the edges, using tack solution if it doesn’t immediately stick. Still struggling? Use a heat gun or a hairdryer on a low setting to secure the edges.

  • Inspect

    Inspect your panel thoroughly. See any bubbles, moisture, … a fruit fly? It happens. If you find anything, remove immediately by peeling back the film and use slip solution to release. Finally, reapply the film and squeegee for a flawless finish. Now you’re a PPF Professional.

  • Take Your Time

    This is a meticulous process that shouldn't be rushed

  • Work in a Clean, Indoor Environment

    To avoid dust and debris getting under the film

  • Use Proper Lighting

    Good lighting helps you see bubbles and imperfections

  • Be Careful with Heat Gun

    Avoid overheating the film or the car’s paint